Sören Posted June 6, 2014 Report Share Posted June 6, 2014 I do not fully understand the English instruktions. What I don't understand is the following: "Apply a thin coat of anaerobic sealant to the bearing cap chamfer and to the cap mating surface adjacent to the seal but not on the seal end" What is "bearing cap chamfer" and "cap mating surface adjacent"? And what type of sealant is "anaerobic sealant"? Link to comment Share on other sites More sharing options...
Göran W Posted June 6, 2014 Report Share Posted June 6, 2014 Till exempel detta: http://www.swedol.se/presto-vaselin-spray-400ml.html Link to comment Share on other sites More sharing options...
Texas Jim Posted June 6, 2014 Report Share Posted June 6, 2014 The "bearing cap chamfer" is the little angle on the block that the bearing cap mates to. http://www.amazon.com/Permatex-51531-Anaerobic-Flange-Sealant/dp/B000HBGL6O Link to comment Share on other sites More sharing options...
Göran W Posted June 6, 2014 Report Share Posted June 6, 2014 Vitsen är alltså att få till en tätning som inte innehåller något frätande dvs det ska vara fritt från syre och därmed inte oxidera. Det är möjligt att man kan hitta den produkt som "Texas Jim" hänvisar till även i Sverige men jag har inte sett den. Link to comment Share on other sites More sharing options...
KHE Posted June 6, 2014 Report Share Posted June 6, 2014 The latest sealant from GM is "GM Engine Sealant" This was not around when the 472 was in production but it is superior to the anerobic sealant. Kevin '93 Fleetwood Brougham '05 Deville '04 Deville 2013 Silverado Z71 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.