lestro Posted July 31, 2014 Report Share Posted July 31, 2014 I'm replacing the heater core and am putting it back together, but I am confused as to what position the upper and lower actuator rods should be in. can someone enlighten me? thanks Quote Link to comment Share on other sites More sharing options...
rockfangd Posted August 1, 2014 Report Share Posted August 1, 2014 There should be a faint mark from where it was previously. Install them in the same spot. I make a mark on the rod at the edge of each side of the clip for ease of install. Then once it is done it is recommended to disconnect the battery, reconnect, turn the key on and dont touch anything for 1 minute. The actuators relearn proper position automatically. But if you touch any of the buttons it will interrupt the cycle. This is to my knowledge lestro 1 Quote GM FAN FOREVER Nice, clean, luxury= fine automobile Link to comment Share on other sites More sharing options...
lestro Posted August 1, 2014 Author Report Share Posted August 1, 2014 Thanks, I appreciate it Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.