ETH002 Posted December 10, 2012 Report Share Posted December 10, 2012 I can not figure out how to reset codes when I re did my ac system. It's full of 134a and new compressor and accumulater and filter with no leaks. But the compressor will not kick in here are the codes Ac 1315 current... Yes it says current on screen Rs 0038 Rf 2560 Link to comment Share on other sites More sharing options...
KHE Posted December 11, 2012 Report Share Posted December 11, 2012 Not sure how you filled the system with R-134a if the code was set. Enter diagnostics and when you see PCM? push the fan down button until ACM? is displayed. Press the fan up button and ACM CODES will be displayed. Press fan up and the codes will be displayed. Then CLEAR ACM CODES? will be displayed. Press fan up and the code will be erased. See your other thread for additional information on the 1315 code and the solution to your issue. Kevin '93 Fleetwood Brougham '05 Deville '04 Deville 2013 Silverado Z71 Link to comment Share on other sites More sharing options...
Tracy Blackmon Posted July 19, 2014 Report Share Posted July 19, 2014 My AC clucth ill not engage.I check my relay and fuse and that are good.I have fire giong to the high and low pressure swicth but no fire going to the air compressor.I am showing a current code of AD 12. Do I need to reset my AC? If so ,what is the code? Link to comment Share on other sites More sharing options...
Göran W Posted July 19, 2014 Report Share Posted July 19, 2014 If there is to little refrigerant in the AC it will not start. Maybe a leak? Must clear code in order to fill and then again to be able to restart AC. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.