davedog Posted May 16, 2008 Report Share Posted May 16, 2008 Anyone ever done it? What little info I can find says it's a dealer job, and the bumper covering has to come off? Surely not! To change a light bulb? Anyone have any pointers? It's been a while since I've been on here. How is everyone? Thanks guys! -dave Crystal Red Tintcoat Exterior | Shale/Brownstone Interior | 32k Link to comment Share on other sites More sharing options...
Logan Posted May 17, 2008 Report Share Posted May 17, 2008 No bumper. But the wheel has to come off. Caution: The high intensity discharge system produces high voltage and current. In order to reduce the risk of severe shocks and burns, the battery negative cable must be disconnected any time service work is being performed on or around the high intensity discharge system. Caution: The high intensity discharge system produces high voltage and current. To reduce the risk of severe shocks and burns: • Never open the high intensity discharge system ballast or the arc tube assembly starter. • Never probe between the high intensity discharge system ballast output connector and the arc tube assembly. Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove either the left front or right front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation . Remove either the left front or right front fascia extension. Refer to Front Bumper Fascia Extension Replacement . 1 Front Turn Signal and Fog Lamp Assembly Screw (Qty: 2) Notice: Refer to Fastener Notice in the Preface section. Procedure Disconnect the forward lamp harness electrical connector from the lamp assembly electrical connector. Tighten 2 N·m (18 lb in). 2 Front Turn Signal and Fog Lamp Assembly Hinge Procedure Rotate the inboard side of the lamp assembly outward in order to release the two hinge points from the park and turn signal lamp bracket. 3 Front Turn Signal and Fog Lamp Assembly Logan Diagnostic LLC www.airbagcrash.com www.ledfix.com www.ledfix.com/yukontaillightrepair.html www.ledfix.com/ledreplacements.html www.ledfix.com/j42385toolrental.html Link to comment Share on other sites More sharing options...
davedog Posted May 18, 2008 Author Report Share Posted May 18, 2008 Thanks Logan! As soon as I get back from vacation I will give this a try & report back.....maybe I'll post some pics too... Crystal Red Tintcoat Exterior | Shale/Brownstone Interior | 32k Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.