William Hill Posted November 2, 2019 Report Share Posted November 2, 2019 I have tried now many times to get the old and now new key fobs to program but they will not communicate with each other. Went to the Caddy dealer yesterday and they also tried to no avail. They also failed to tell me how to go about checking or fixing the problem. The interior trunk unlock button is also not working but the lock unlock buttons on the doors are. The only codes I have are P1860 for my TCC and A PZ 1558 & PZ 2472. This is A 1996 Concourus with 130,000 miles Quote Link to comment Share on other sites More sharing options...
rockfangd Posted November 3, 2019 Report Share Posted November 3, 2019 Welcome To CaddyInfo Forum. So if I have this right you are getting into program mode via the IPC but the keyfob does not respond. The module is behind the back seat. I cannot recall the name of it. I will try and find the picture of the layout. The module is square and is about 8" square. About 1" deep. You should see foil on the panel right near it jetting in 2 directions. That was GMs idea to extend the poor range they had. I wonder if that module could be down. Check your fuses behind the back seat in the trunk. Driver side. Lower. Dont expect much help from the dealer as these are getting pretty rare and onboard diagnostics are non existent now. Can you please post the procedure that you used to attempt to program them. Thank you Quote GM FAN FOREVER Nice, clean, luxury= fine automobile Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.