Myc Posted June 15, 2019 Report Share Posted June 15, 2019 Due to a low impact accident the bumper moulding is touching the wheel. Any suggestions on how to pull it out? Quote Link to comment Share on other sites More sharing options...
rockfangd Posted June 15, 2019 Report Share Posted June 15, 2019 Hello. Need more info to answer that. Is it front or rear? The struts will have to be replaced (bumper shock absorbers) The wheel well skirt likely is broken as well The absorbers are there to absorb the impact and prevent (to an extent) further damage into the structure or body. I have never really seen them return, and even if it was one side I would pretty well guarantee the other side is pushed in as well. Welcome to CaddyInfo Forum Quote GM FAN FOREVER Nice, clean, luxury= fine automobile Link to comment Share on other sites More sharing options...
Myc Posted June 16, 2019 Author Report Share Posted June 16, 2019 The front passenger. The driver side seems to be fine though. Quote Link to comment Share on other sites More sharing options...
rockfangd Posted June 16, 2019 Report Share Posted June 16, 2019 These are them. I honestly only buy used if I saw the car they came off of. One or both could be tweaked and you may not see it until they are installed. I had to replace both on my 97 deville, The right one was pushed in about a inch, the left about a half inch. I assume the impact was on the right Quote GM FAN FOREVER Nice, clean, luxury= fine automobile Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.