liv4rc Posted November 24, 2004 Report Share Posted November 24, 2004 Looking for a few answers-Please help. 1. What happens if you unplug the vacumm pump? Will it cause a service light to come on? 2. How do you reset service engine light? Any help would be great. Thanks Bill Link to comment Share on other sites More sharing options...
KHE Posted November 24, 2004 Report Share Posted November 24, 2004 Why do you want to unplug the vacuum pump? It is there to provide additional vacuum to supplement the engine vacuum for such things as the power brake booster and climate controls. Simultaneously press and hold the OFF and WARMER buttons on the climate control panel. The system will go into a segment check and then display the trouble codes. Write them down and post back. When the system displays .7.0, it is awaiting further input. It's been a long time since I worked on a 4100 but I think you press and hold the OFF and one of the buttons (RANGE??) on the fuel data panel to clear the codes. Kevin '93 Fleetwood Brougham '05 Deville '04 Deville 2013 Silverado Z71 Link to comment Share on other sites More sharing options...
liv4rc Posted November 24, 2004 Author Report Share Posted November 24, 2004 The pump makes a Really loud noise. I ordered a new one but it is a few days out. I will check the codes and post. Thank you so much for the quick reply Link to comment Share on other sites More sharing options...
liv4rc Posted November 24, 2004 Author Report Share Posted November 24, 2004 ok- the codes are-E44 and E47, then it shows E.E. When do I try and clear the codes? When it shows .7.0 Thanks again Link to comment Share on other sites More sharing options...
KIMO Posted November 26, 2004 Report Share Posted November 26, 2004 Hey there... E44:Oxygen (O2) sensor lean E47:Body Control Module (BCM) to Electronic Control Module (ECM) data fault As for the E.E and E. prefixes: .E. means the codes are stored in the history of the ECM. E.E. are the current codes. To erase the ECM codes, simultaneously press the OFF and HI buttons until E.0.0 is displayed. As for the BCM codes, press OFF and LO until F.0.0 is displayed. Hope this helps, are you experiencing any other symptoms? -KIMO- Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.