dally Posted September 1, 2004 Report Share Posted September 1, 2004 I just finished putting a new solenoid kit in and now I have no reverse and the car is slipping in all drive gears. I checked and the only code showing is p024. Link to comment Share on other sites More sharing options...
Ranger Posted September 1, 2004 Report Share Posted September 1, 2004 P024 (E024) .................................... Vehicle Speed Sensor signal to TCC Link to comment Share on other sites More sharing options...
Barry94 Posted September 1, 2004 Report Share Posted September 1, 2004 If you had reverse before you replaced the solenoids, then you can only come to one conclusion, sSomething didn't get assembled correctly. Not having a good knowledge of the transmission, I can only think of the easy things to screw up, and that is the "balls". I did my solenoids last year, and needed the manual to get all the balls back in the correct location. This may not be you problem, however something "isn't right". Sorry I can't be of more help. I do have a picture of the ball locations if you need it. Barry 2008 STS V82016 Colorado Z711970 Corvette LT-1 Coupe Link to comment Share on other sites More sharing options...
JBuckley Posted September 1, 2004 Report Share Posted September 1, 2004 There is only one other thing I can think of other than the check balls being in the wrong place, and that is that the Lo/Reverse band did not get slid into the proper position. John Link to comment Share on other sites More sharing options...
Cadillac STS Posted September 1, 2004 Report Share Posted September 1, 2004 hey the first time i installed the solenoids i had the same problem...wouldnt go into any gear...so i got back under the car an did everything all over again, making sure the check balls were in the right place and stayed there Link to comment Share on other sites More sharing options...
dally Posted September 1, 2004 Author Report Share Posted September 1, 2004 Thanks for the replies guys. I ggave into the women and took it to the shop. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.