alexmarti Posted June 10, 2009 Report Share Posted June 10, 2009 Hi All, Seems when I turn my A/C on i'm only getting cold air from the 2 oassenger side vents, the 2 driver vents continue to blow warm outside air. Could this be actuator problem, and could I easily get to it once removing the dash panel? Freon is at a good level and compressor is fine. Thanks Link to comment Share on other sites More sharing options...
Ranger Posted June 10, 2009 Report Share Posted June 10, 2009 That is a symptom of low refrigerant on a dual zone system. IF you are absolutely, positively, 100% sure that it is not a refrigerant problem, then it would have to be an actuator. Link to comment Share on other sites More sharing options...
alexmarti Posted June 10, 2009 Author Report Share Posted June 10, 2009 That is a symptom of low refrigerant on a dual zone system. IF you are absolutely, positively, 100% sure that it is not a refrigerant problem, then it would have to be an actuator. Just put a test gauge and it show full and blowing real cold air from the passenger side, and outside air from driver. Is the actuator hard to get to? thanks Link to comment Share on other sites More sharing options...
Ranger Posted June 11, 2009 Report Share Posted June 11, 2009 On the pre 2000's they where behind the glove box. One was reached after removing the glove box and the other from below. I'm not positive about the 2000+. A FSM would be handy to have. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.