Larry Posted June 19, 2007 Report Share Posted June 19, 2007 I have just had my compressor and acumulator replaced . The air is not very cold. He said he could only get it down to 54 degrees, it has a full charge. But its not very cold at all. I replaced the heater core about 9 months ago and I'm wondering if I messed the linkage up. When I put air on econo air its just outside air. And I think I can feel warm air coming out with cool air on max. Any suggestions. When I get time I will pull glove box out and check. Thanks so much Link to comment Share on other sites More sharing options...
Ranger Posted June 20, 2007 Report Share Posted June 20, 2007 Start by pulling the codes. If you messed with the air mix door linkage, you may have not set it correctly upon reassembly. Link to comment Share on other sites More sharing options...
daniel812 Posted June 20, 2007 Report Share Posted June 20, 2007 when they replaced the compressor and accumulator, are you sure the evac and recharged properly? If they didnt "vaccuum"out the moisture from the system and lines, this will cause your problem Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.