Jump to content
CaddyInfo Cadillac Forum

Compressor wiring diagram required


KleenTeam

Recommended Posts

Hi guys, I have been searching the internet for some hours now and am drawing a blank.

If someone has a wiring diagram of the air suspension for a 2000 DTS I would be eternally grateful. At the moment I have to stand in the trunk and use a foot pump to get some pressure in there.

Also if someone could point me in the direction of a workshop manual too.

Thanks

Ian

Link to comment
Share on other sites


First step would be to pull the trouble codes from the OBD system and report them here.

Can you hear the compressor running?

Jim

Drive your car.

Use your cell phone.

CHOOSE ONE !

Link to comment
Share on other sites

Unless your vehicle has been modified there would be a 4 pin connector for the compressor and no need to mess with the wiring. If the connector has been disturbed or modified, the original factory installation was wired as

pin A = white wire (solid state ground connection for the exhaust solenoid controlled by the electronic suspension control module)

B = green wire (compressor motor power from a relay in the rear fuse block, "ELC Relay")

C = red wire from the same fuse block (exhaust solenoid power)

D = black wire to ground

The compressor and solenoid are protected by a 30A fuse in the rear fuse block, "ELC".

The attached file will display codes for you.

Jim

Drive your car.

Use your cell phone.

CHOOSE ONE !

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...