lowsixfo64 Posted April 25, 2005 Report Share Posted April 25, 2005 how should i replace my crank position sensor on a 2000 deville northstar motor Link to comment Share on other sites More sharing options...
JimD Posted April 25, 2005 Report Share Posted April 25, 2005 Remove bottom trim panel. Drop oil filter. Remove oil filter adapter. This will allow working room to R & R both crank position sensors. And I would replace both of them while you are in there. Make a note or take a pix of the connector colors on the top and the bottom sensors. One quarter inch drive wrenches will work fine. You should also buy two new oil filter adapter O rings. Surgical cleanliness is important. Jim Drive your car. Use your cell phone. CHOOSE ONE ! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.