Jump to content

DTS brake pedal position question!


Recommended Posts

I am installing a trailer brake controller in my 2007 DTS. I need to attach a wire from the controller to the cold side of the pedal sensor. Anybody know which wire that is or do you have a schematic of the wiring to the sensor?

Link to comment
Share on other sites


Hmm. 

Did the instruction specify for your type of switch? 

I only ask this because with these newer brake pedal position sensors I have not wired anything to them.

I can try and look up a diagram tomorrow. I would say very likely it is not prewired for a brake control output. May be for the lighting but that's it. So you ran a harness to the rear I assume?

GM FAN FOREVER

Nice, clean, luxury= fine automobile

Link to comment
Share on other sites

Save your time. I learned that the sensor wont work and I will need to attach to the CHMSL to get a positive connection only when the brakes are applied. There is not any controller connections on the DTS.

Link to comment
Share on other sites

That's what I was leaning toward.

Different signals between the brake controller and the position sensor.

If you don't mind me asking, what are you looking to tow with brakes?

GM FAN FOREVER

Nice, clean, luxury= fine automobile

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...