Sign in to follow this  

Recommended Posts


Take a close look at the sockets before spending too much time. Cadillacs of that era could have bad grounds inside the socket plastic. See burn mark in plastic in socket on right. 

The fix is to splice on a new socket. 

burntsocket.jpg

Share this post


Link to post
Share on other sites

I have a 98 STS that needs the sockets as Logan stated, I prolonged the agony and bought a little time with dielectric grease because parts are so hard to come by where I live at the end of the world.

BUT, they should be replaced

Edited by OldCadTech

THERE IS ALWAYS ENOUGH TIME TO DO THE JOB RIGHT - THERE IS NEVER ENOUGH TIME TO DO THE JOB AGAIN !!!

Share this post


Link to post
Share on other sites

I would be checking the brown wire that goes inside the trunk. It likely splices in with the left side.

You will also find out if you have the factory trailer harness

If you do that will be spliced in also.

I am thinking the wire is bad somewhere between the splice and the right side taillight. Likely obvious when you find it.

The wiring runs under the plastic trim where the pull down latch is 


GM FAN FOREVER

Nice, clean, luxury= fine automobile

Share this post


Link to post
Share on other sites

interesting. 

Glad you figured it out. 

Best of luck with your seville


GM FAN FOREVER

Nice, clean, luxury= fine automobile

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.