SeaneOday Posted September 9, 2013 Report Share Posted September 9, 2013 Hi guys, I've been researching this but I can't isolate the problem. Brake, ABS, TC dash lights came on yesterday, car runs and stops fine. Ran codes, these came up. ABS c1214- system relay contact ABS c1248- EBCM turned warning light on The only other thing current is a PCM p0137 code for my O2 B1S2, so unrelated I believe. Pulled my tires off, all wires connected and look good. Brake fluid level is full. I am going out now to check / clean the EBCM connector and investigate some more. But... Questions: 1. my rear pads are about done, any chance that would give me the c1214? Without any other brake warning codes or messages? 2. I've got "history" codes out the wazu, I will list them below. Any chances there is a connection that is loose where all this mess could intersect? I say "loose" because I figured if it were melted, shorted or unplugged there would be more "current" 3. What is the probability I will have to change out my EBCM? Codes marked "history": IPC v1000- u1301 u1016 PCM po463 RCC v1000 RFA b3109 SDM u1000 See what I mean? Loose connection? ** money saving advice always welcomed! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.