Jump to content
CaddyInfo Cadillac Forum

rear suspension trim height


Recommended Posts

Hi All

I have a '97 Seville STS with rear air suspension. The rear end sits too high by an inch or two. The load leveling pump works well enough I hear it pump every time i start the car.

Problem is it sits an inch or two too high by the time th epump is done.

Is there any way to have it sit lower and not mess with the geometry of the car? It looks like a 60s hotrod all jacked up in the rear :P

Link to comment
Share on other sites

Check to see if the height sensor on the rear suspension is misadjusted or dislodged from its mounting. It is also possible the exhaust solenoid on the level control compressor is not working. That should set a code. Did you check for codes?

'93 Fleetwood Brougham
'05 Deville
'04 Deville
2013 Silverado Z71

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...