Larry Posted April 16, 2008 Report Share Posted April 16, 2008 I fixed my pull down the other day on my 96 deville. I had checked voltage from top switch 12 volts and ground seemed ok. I went to bottom motor. Unbolted it, bolts go into plastic case. I unscrewed moter cover, and found motor somewhat frozen. Pulled it out , lubricated . Pulled armature out and lubricated with grease at bottom of steel case. Re-insatalled armature and ,had to take care putting brushes back in .You need to push them in ,and hold with your finger and use a small screwdriver. Do this very easy. Put back together, but did not seem to work. so I found a screw which held the switch case to asembly, cleaned and used wd40, works great Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.