CadiKing Posted January 14, 2008 Report Share Posted January 14, 2008 Hi Everyone, Replaced rear rotors and pads on '97 Deville. Now the cars starts in second gear and keeps the brake light on... Codes... DTC C1223 LR Wheel Speed Sensor Input Signal is 0 DTC C1234 LR Wheel Speed Circuit Open or Shorted I must have done something to set the code. cannot find the disconnection.. Any thoughts..? thanks jim Link to comment Share on other sites More sharing options...
JimD Posted January 14, 2008 Report Share Posted January 14, 2008 ....I must have done something to set the code. cannot find the disconnection.. Any thoughts..? I can agree with that thought. Your LR wheel speed sensor connector-wire harness is the most likely culprit. Unless you believe in coincidence and the sensor-hub just happened to fail while you had the car in the air. Jim Drive your car. Use your cell phone. CHOOSE ONE ! Link to comment Share on other sites More sharing options...
CadiKing Posted January 14, 2008 Author Report Share Posted January 14, 2008 ....I must have done something to set the code. cannot find the disconnection.. Any thoughts..? I can agree with that thought. Your LR wheel speed sensor connector-wire harness is the most likely culprit. Unless you believe in coincidence and the sensor-hub just happened to fail while you had the car in the air. Thnks Jim, I will put it up in the air again and check it out! jim Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.