Search the Community
Showing results for tags 'MAP Sensor'.
I encountered an interesting phenomenon. I've had a hard P0741 fault for 3 or 4 years. When I cleared my DTC's the P0741 code would return immediately after 2 consecutive trips. I also had shifting problems. Additionally, I had intermittent hard shifts and the "chuggling" symptom at idle. I also had a vacuum leak from the intake to PCV valve hose line. Long term fuel trims were a consistent +19 to +20. I replaced the PCV hose line. When I started it, the engine stalled with a P0101 DTC. After some investigation, I found a damaged MAP sensor. The sensor stem had broken resulting in the MAP sensor over-reporting engine load and un-metered air entering the throttle body. I replaced the MAP sensor and this corrected the idle problem and the P0101 code. I checked the LTFT and they were back to normal levels. When I did the test drive, the P0741 did not set. I have driven about 100 miles since then, making 6 or seven trips over four or five days and the P0741 has not returned. I do regularly drive over 41 MPH and I've verified the RPMs drop when I'm in 4th and reach 41. Gas mileage is now around 19 MPG in town while it was in the low 16's before the repair. The transmission shifts normally now.
BugsyC posted a topic in Cadillac Deville, Eldorado, Seville, Fleetwood, Sixty SpecialP1106 just popped up.It's an intermittent high voltage to the MAP sensor..What would cause this? Is it a vacuum leak somewhere?? Where to start looking? 02 Eldorado ESC
So after failing emissions twice for HC (CO and Nox close), I decided to pull the intake mainfold (beauty cover) cover to inspect. Fuel is everywhere inside. Thinking FPR. I'm trying to disconnect the injector harness where it goes through the plastic fuel rail holder. Doesn't look like a connector really. See picture below: BTW, that cup where the wires go through was filled to the top with fuel. Fuel kinda looked like some oil in it too, but not sure how that much oil could get in there. I think it's just old fuel that has evaporated over time and "thickened" so to speak, also mixing with the plastics. I'd really like to remove it so I can clean everything up and inspect wires. Any help would be greatly appreciated. Thanks gents.