Peptember

Registered
  • Content Count

    1
  • Joined

  • Last visited

About Peptember

  • Rank
    Lurker (1-2 posts)

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. to keep your dual overhead cams in place in relation to each other while you do a head job just set your timing at the beginning of its cycle then take two crescent wrenches and put them on the hexes at the end of your camshafts so that they are faced in word and cross each other this is where you can take a vice grip and lock them together to keep them from moving so that you are able 2 put your head back into place saving you time