Otten33

Registered
  • Content Count

    96
  • Joined

  • Last visited

  • Days Won

    5

Otten33 last won the day on May 28

Otten33 had the most liked content!

About Otten33

  • Rank
    Fanatic (50+ posts)

Previous Fields

  • Car Model and Year
    Cadillac Deville DTS 2004
  1. Ok tried fuse jumper.. car started a few times but died quickly, within seconds. Checked fuel pressure. It was at zero. Put test light on connectors at fuel pump. I had power going to both connectors. I reinstalled old fuel pump at pressure shot up to 38 PSI just like before. Still wouldn't start. Just cranked. Sprayed ether in the intake and still it would start. Last time I had checked spark I was getting blue spark but I only checked on the front bank. Back bank looked like a pain in the but to get too. The new fuel pump was brand new AC Delco. Seems to be defective. Also wasn't sure on orientation of fuel pump relay so I plugged in to the left side one time and then into right side of relay ports. Right side blew fuse immediately. Whatever that means.
  2. Ok guys brief update. New cam sensor installed. Pretty easy once the expansion coolant tank is moved out of the way. Found fuse jumper. Have yet to try it though. Little unsure what to do with it though. From picture it looks like I'm plugging in at pin 87a and 30. What size fuse should I use? 20 amp? Sorry about the delay. Do lawn care on the side and have been crazy busy lately. Thanks for all the advice.
  3. I haven't had hardly anytime to work on this. I did find the Cam sensor. It was completely covered in oil. Only found it after dousing area in brake clean. I haven't replaced it yet. It looks like a hell of a fit. I should be able to squeeze a wrench in there and take off the sensor. Hopefully once off I can pull towards me to disconnect the connector. I tried finding a fuse jumper locally but NAPA doesn't seem to have one. I will check autozone or oreilleys tonight. If not I will order one from Amazon.
  4. That's where I was looking but didn't see anything.. I'll go back out and be more thorough I guess. Thanks for the orientation picture Logan.
  5. Must be at the back of the engine between the engine and firewall.
  6. Flipping the relay around did nothing. Still no pressure. Cam sensor came in and was looking around for it but can't seem to find it. I'll double check your picture bodybyfisher.
  7. How do you use a fuse jumper. I will turn relay around and see if I get pressure back. Let you know in a bit.
  8. So i think I should pull fuel pump back out and check connections in pump and connector. I will install old pump and see if I have pressure. Eliminate if it's the pump or not. I wasn't aware that relay had to be plugged in any certain way. Which orientation should it be in? Fuse jumper?
  9. I hope mine is not as extreme as his and that the camshaft sensor corrects issue. Is that issue related to fuel pump not getting power? Seems to me like a separate issue. Both causing a no start situation. Is that right?
  10. I ordered the camshaft sensor.. should get it Monday or Tuesday.
  11. Is this picture from the bottom side of passenger side of engine?