Vince P

Barry, Thank you. A very elegant solution. The wire color code on my position sensors are different. It is easy to figure out what wire the power, signal and gound are. Your circuit is very simple. One 2.5Volt Zener diode, One 220ohm resistor (1/4watt). Add some RTV to seal everything. Again Thank you Vince

Barry, It is interesting that this post poped up in 2012 (orignally posted in 2005) If it is still available, I would also like a copy of your Circuit to replace the sensor. I have had SO60 and SO61 codes for years The reference maydog web site no longer works Thank you VinceP

Timesert issue Car mileage---------------152,000 Timesert--------------------No Vince P

Psycho, Another tool web site: http://www.toolweb.com/discounttools.biz/s...results&srch=kw This is a Lisle tool. I bought one some time ago for $13 plus shipping. I recieved it in three days. Notes: 1. The pump is removed by turning it CLOCKWISE 2. There is an index tab on the pump note where it goes. Mine was at 0200hrs. They are not all in the same place. Once the air filter and tube to the throttle body is removed, the job is very easy with plenty of space. I ended up using an impact wrench on the Lisle tool. The dealer that installed it glued it in place. Vince P