BodybyFisher
-
Posts
18,065 -
Joined
-
Last visited
-
Days Won
105
Content Type
Blogs
Profiles
Forums
Events
Store
Gallery
Articles
Status Replies posted by BodybyFisher
-
Hello, do you still have these shocks for Sevilla?
-
I am sorry that I never got back to you on this, are you still interested? 2020 was a mess for me, major home renovation, covid, etc.. Hope all is good, Mike
-
-
Hello, do you still have these shocks for Sevilla?
-
Hello, do you still have these shocks for Sevilla?
-
I do, let me know if you are interested. Ill need to pull them out of storage. Mike
-
-
Good morning Mike. I've been searching in the forum about rich cold start. I have a 1993 Cadillac deville 4.9 v8. I've done maintenance. full tune up. Plugs, wires, cap and rotor. New EGR, and new PCV valve. Throttle body cleaned and air intakes (those were bad) checked the timing yesterday (at 24 degrees) don't know why but I'll bring it down. Cold start rough... too much fuel. Runs perfect after warm. Any suggestions about the rich cold start? Any info it would be much appreciated. thank you.
-
Check valve?, you mean fuel pressure regulator from your description above. Yes, those fuel pressures sound problematic, the regulator's diaphragm is no doubt leaking.
Did you get this fixed? The regulator is attached to the fuel rail. I can post photos if you need. Sorry again for my delayed reply, I have been away from the board with much more pressing issues. Mike
-
-
Good morning Mike. I've been searching in the forum about rich cold start. I have a 1993 Cadillac deville 4.9 v8. I've done maintenance. full tune up. Plugs, wires, cap and rotor. New EGR, and new PCV valve. Throttle body cleaned and air intakes (those were bad) checked the timing yesterday (at 24 degrees) don't know why but I'll bring it down. Cold start rough... too much fuel. Runs perfect after warm. Any suggestions about the rich cold start? Any info it would be much appreciated. thank you.
-
I am sorry, I just saw your message here today, are you still experiencing problems? Mike
I will send a DM
-
-
how do I get a discount from northstar performance,,,i have two of these bitches to do
-
You are best to contact them directly, speak to Jake. Good luck with the repair, let us know if you need any help, a few members here have done the job.
-
-
Is it possible to have a bad multifuction switch that is preventing my high beams turn sugnals and hazard lights from operating. ....even though my wipers still work perfectly which is located on the same multifunction switch???? Im lost on this issue
-
Will I am sorry I did not get back to you, I have been away from the board. If you have not fixed this yet, I would check relays and fuses, check for corrosion, etc, it sounds like there is a common problem, like a bad ground or power point, let me know what you find. I have to check to see why I am not getting notifications from this forum, thanks
-
-
You said you have a power seat diagnostic chart. Thank you also. Mike
-
I find the GMsi to be cumbersome to share. Great info, but tough to share here. Let me know if you need anything
-
-
You said you have a power seat diagnostic chart. Thank you also. Mike
-
Ok, cool, hope it helps
-
-
You said you have a power seat diagnostic chart. Thank you also. Mike
-
Did it come through via PM ok?
-
